Difference between revisions of "Turntable disassembly"
From Organic Design wiki
(general comments) |
m |
||
| (6 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | [[ | + | [[Image:Pioneer-turntable.jpg]] |
| + | |||
==Platter and drive mechanisim== | ==Platter and drive mechanisim== | ||
| − | [[Image:Platter.jpg | + | [[Image:Platter.jpg]] |
Once you remove the slip mat the platter is exposed. The sticker talks about how to correctly fit the drive belt. As you lift the platter the drive belt will slip off. | Once you remove the slip mat the platter is exposed. The sticker talks about how to correctly fit the drive belt. As you lift the platter the drive belt will slip off. | ||
| − | [[Image:Bed-no-platter.jpg | + | [[Image:Bed-no-platter.jpg]] |
With the platter removed we see the drive, auto-return and start-stop mechanism. Notice that the drive gear is suspended separately from the bed of the turntable. A very nice design. | With the platter removed we see the drive, auto-return and start-stop mechanism. Notice that the drive gear is suspended separately from the bed of the turntable. A very nice design. | ||
| − | [[Image:Drive-mechanisim-cu.jpg | + | [[Image:Drive-mechanisim-cu.jpg]] |
I was a little concerned that adding a push button to the controls might cause jumping problems if the button was pressed too roughly. As you can see from the enlargment this will not be a problem. | I was a little concerned that adding a push button to the controls might cause jumping problems if the button was pressed too roughly. As you can see from the enlargment this will not be a problem. | ||
| − | + | = Underside internals = | |
| − | [[Image:Turntable-base.jpg | + | [[Image:Turntable-base.jpg]] |
| − | [[Image:Under-side.jpg | + | [[Image:Under-side.jpg]] |
| − | [[Image:Transformer.jpg | + | [[Image:Transformer.jpg]] |
| − | [[Image:Power-tagboard | + | [[Image:Power-tagboard.jpg]] |
| − | [[Image:Power-tagboard.jpg | + | [[Image:Power-tagboard-reverse.jpg]] |
| − | [[Image:Joinery.jpg | + | [[Image:Joinery.jpg]] |
| + | *See [[Turntable USB interface]] for more technical information. | ||
Latest revision as of 21:18, 10 February 2007
Error creating thumbnail: Unable to save thumbnail to destination
Platter and drive mechanisim
Error creating thumbnail: Unable to save thumbnail to destination
Once you remove the slip mat the platter is exposed. The sticker talks about how to correctly fit the drive belt. As you lift the platter the drive belt will slip off.
Error creating thumbnail: Unable to save thumbnail to destination
With the platter removed we see the drive, auto-return and start-stop mechanism. Notice that the drive gear is suspended separately from the bed of the turntable. A very nice design.
Error creating thumbnail: Unable to save thumbnail to destination
I was a little concerned that adding a push button to the controls might cause jumping problems if the button was pressed too roughly. As you can see from the enlargment this will not be a problem.
Underside internals
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
Error creating thumbnail: Unable to save thumbnail to destination
- See Turntable USB interface for more technical information.
